You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
Use existing ports on toolhead board or controller instead of using the ATTtiny85 and create a Klipper Macro
#2
This seems like a natural progression and an even simpler solution. I just don't know Klipper well enough to develop a solution.
It would seem that one could connect the soft potentiometer to a 3 pin end-stop port on a controller board or toolhead board and write a macro that would do what the probe_calibrate macro does.
If anyone has suggestions/experience with Klipper macros, I'd be interested in learning more!
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
Uh oh!
There was an error while loading. Please reload this page.
This seems like a natural progression and an even simpler solution. I just don't know Klipper well enough to develop a solution.
It would seem that one could connect the soft potentiometer to a 3 pin end-stop port on a controller board or toolhead board and write a macro that would do what the probe_calibrate macro does.
If anyone has suggestions/experience with Klipper macros, I'd be interested in learning more!
All reactions